Types of Rotap Sieve Shaker

Rotap sieve shaker, as a more important type of vibrating screen in laboratory screening equipment, mainly has two different designs: belt type rotap sieve shaker and gear type rotap sieve shaker, which belt type rotap sieve shaker and gear type rotap sieve shaker Which device is better? Of course a belt rotap sieve shaker is better than a geared rotap sieve shaker! Let's hear why.

I believe that many users are not particularly familiar with the concept of belt-type rotap sieve shaker or gear-type rotap sieve shaker, so I will first introduce the definitions between the two here, so that users can better understand the difference. .

1. Gear rotap sieve shaker

The gear type rotap sieve shaker is installed on a horizontal foundation with anchor bolts, and the circuit and grounding are installed according to the electrical regulations. The gear-type rotap sieve shaker motor passes through the synchronous belt, drives the gear to change speed and makes the main shaft rotate, the main shaft drives the eccentric wheel, the slide plate drives the test sieve to shake left and right, and at the same time drives the ejector gear to rotate, hit the hammer, slap the test sieve, and make the test sieve , Material sieving in the sample sieve.

2. Belt type rotap sieve shaker

Belt type rotap sieve shaker is a new type of rotap sieve shaker upgraded from gear rotap sieve shaker. The eccentric wheel group adopts the integral method, which is accurate and convenient to install again. The rotating part adopts standard bearings, which is not easy to wear, and the replacement is simple and low cost. , greatly reducing the difficulty and cost of maintenance.

Why are belt rotap sieve shakers better?

Choosing a belt-type rotap sieve shaker instead of a gear-type rotap sieve shaker is mainly considered from the following two aspects:

1. Easier to operate

The belt-type rotap sieve shaker adopts an integral method, which is accurate and convenient to install again. The rotating part adopts standard bearings, which is not easy to wear, and is simple to replace and easy to operate.

The gear type rotap sieve shaker needs to be filled with oil before the first time. When the rotap sieve shaker is started, the ejector rod needs to be lifted up and fixed with screws. If there is a failure during operation, the thread head needs to be readjusted after the shutdown. It is very easy Cause the rotap sieve shaker fuse to burn out.

2. Longer service life

The belt type rotap sieve shaker has no direct contact between the gears, so there is no wear and tear, more durable and lower cost. And the adaptability between the synchronous belt and the gear is better, and only the belt needs to be replaced during maintenance.

The gear type rotap sieve shaker needs to check whether the insurance is normal when using it, otherwise it needs to be replaced. The gear type rotap sieve shaker has a limited service life. When the gear is damaged, it needs to be returned to the factory for repair, and the maintenance cost is high.

For more detailed information, please contact Dahan Machinery.