How to adjust the amplitude of the ultrasonic sifter?

The ultrasonic sifter is equipped with an ultrasonic transducer on the basis of the ordinary vibrating screen. In the course of the user's use, if the situation does not meet the production requirements, the amplitude of the ultrasonic sifter needs to be adjusted, but many users are on the ultrasonic wave. The shaker amplitude adjustment does not know how to operate, so Dahan manufacturers are here to introduce you.

Under normal circumstances, the ultrasonic sifter has been adjusted before leaving the factory, the user can directly put into use, the user needs to pay more attention when adjusting the amplitude of the ultrasonic sifter, so as not to affect the normal production due to the adjustment. The adjustment of the amplitude of the ultrasonic sifter is related to the material screening output, precision, etc. The amplitude adjustment is mainly caused by the following three stages:

Low amplitude

The low amplitude is mainly suitable for materials with heavier specific gravity and good fluidity, so the lower amplitude is adopted.

Medium amplitude

The medium amplitude ultrasonic sifter is mainly used for the screening of general materials, and the fineness requirement is general, and the material can be ensured that the material does not block the net.

High amplitude

This stage is suitable for materials with light specific gravity, very high viscosity, and static electricity. It is necessary to use a higher amplitude to thoroughly sift the material, decompose the adhering material and reduce the sieve material.

Ultrasonic sifter eccentric block adjustment method

1)The weight of the eccentric block

Increasing the weight of the eccentric mass (increasing the secondary eccentric weight) can increase the amplitude of the ultrasonic sifter, the lower eccentric mass controls the upper and lower amplitudes of the screening machine, and the upper eccentric mass controls the left and right amplitude of the screening machine.

2)The angle of the eccentric block

Adjusting the angle of the eccentric block can control the running track of the material on the screen. The specific adjustment angle can be adjusted according to the specification of the supplied ultrasonic sifter and adjusted according to the material characteristics.

The method of adjusting the amplitude of the ultrasonic sifter is introduced here. If you need help, you can consult the Dahan ultrasonic sifter manufacturer at any time.